Science Links Japan | The rotation alignment of the femur component in the artificial knee joint placement technique. The comparison of the dependent cut and independent cut method.

The rotation alignment of the femur component in the artificial knee joint placement technique. The comparison of the dependent cut and independent cut method.

Accession number;03A0061352

Title;The rotation alignment of the femur component in the artificial knee joint placement technique. The comparison of the dependent cut and independent cut method.

Author; SHIRAISHI KOICHI (Iizukabyoin Seikeigeka) ARAI KEN (Iizukabyoin Seikeigeka) HAMASAKI AKIHIKO (Iizukabyoin Seikeigeka) MOROOKA TAKAAKI (Iizukabyoin Seikeigeka) TOMOHIRO SHIN'ICHI (Iizukabyoin Seikeigeka) TABERI RYUICHI (Iizukabyoin Seikeigeka) JONO OSAMU (Iizukabyoin Seikeigeka) YO SHOKEN (Iizukabyoin Seikeigeka)

Journal Title;Nippon Jinko Kansetsu Gakkaishi

Journal Code:L0423A

ISSN:0913-3968

VOL.32;NO.;PAGE.97-98(2002)

Figure&Table&Reference;FIG.3, REF.3

Pub. Country;Japan

Language;Japanese

Abstract;For the case of 26 rear stabilized type TKA (artificial knee joint placement technique) for the inner type gonarthrosis in January, 2000 - October, 2001, the difference between rotating angle of the I and II method in taking a balance by the bending gap was examined.Range of motion of the extension motion was significantly improved.However, there was no difference from the preoperative in the bending motion.The factor of the difference of rotating angle was examined.

Related Articles;