A CAD-based Vision System using an ID-Tag and the Networ
|
Accession number;04A0637697
|
| Title;A CAD-based Vision System using an ID-Tag and the Networ |
| Author;
NAKAGAWA MUNEHIRO
(Yamagata Univ., Fac. Engineering, JPN)
BABA KAZUNORI
(Yamagata Univ., Fac. Engineering, JPN)
KUGIMIYA TOYOHITO
(Yamagata Univ., Fac. Engineering, JPN)
SATO MASAHARU
(Yamagata Univ., Fac. Engineering, JPN)
HONTANI HIDEKATA
(Yamagata Univ., Fac. Engineering, JPN)
|
Journal Title;Transactions of the Institute of Electrical Engineering of Japan. E
|
Journal Code:L3098A
|
ISSN:1341-8939
|
|
VOL.124;NO.9;PAGE.327-335(2004)
|
| Figure&Table&Reference;FIG.12, REF.25 |
| Pub. Country;Japan |
| Language;Japanese |
| Abstract;A CAD-based vision system which identifies an object using its ID tag and downloads the CAD data of the object via the network was proposed. The object not be identified by the image, and it is identified according to the tag which shows ID of the object, and the model is acquired via the network. By this fact, the system captures an image of the object, and recognizes its ID number based on the image of the tag. It is proposed the CAD-based vision system which uses a circular ID tag. It can be also utilized for initial position and attitude estimation which are necessary, when the motion of the object is tracked. |
|
|
|
Related Articles;
|
|
|
