|
List of Jounal Titles
A to Z index of Journal Title. Choose a letter.
Journal of the Society of Naval Architects of Japan
- Analysis of Diffraction Waves Around a Ship Using Projected Light Distribution Method.
- Numerical Simulation of Fully-Nonlinear Wave Motions around Arctic and Offshore Structures.
- A Study on the Wave Diffraction Problem of Annular plates.
- Capsizing Probability of an Indonesian RoRo Passenger Ship in Irregular Beam Seas. Second Report.
- Consideration on the Establishment of Rough-Sea State. For guaranteeing the ship performances in operating condition.
- A Theoretical Approach to Hydroelastic Behavior of a Very Large Floating Structure in Regular Waves. Fourth Report.
- Application of CFD to the Study of Ship Manoeuvrability on Initial Stage of Hull Design.
- Study of Interaction between Ship Hull and Rudder by Computation.
- Model Experiment and Sea Trial for Investigating Manoeuvrability of a Training Ship.
- Free Surface Wave Elevation Interacted with Compression Waves in Seawater Caused by Earthquake.
- Fundamental Study on Elastic Vibration of Sea Bottom under Hydrodynamic Pressure due to Sea Shock.
- Fundamental Study on Elastic Deformation of Seabed under High Frequency Oscillation of Floating Structures.
- An Experimental and Numerical Study on Bubble Plume Behavior in Stratification.
- A Numerical Study on Flow Field around a Tidal-Jet-Generator Deliberating over Coastal Environmental Control.
- Very Thin Layer Method for Solving High Schmidt Number Flow on Unstructured Hybrid Mesh.
- The Characteristic Analysis of Turbulent Diffusion on the Functional Design of Marine Systems. Part 2. The Effect of Heat Radiation on Turbulent Natural Convection in an Enclosure.
- An Estimation of Environmental Impact of Large-Scale Platform using Landsat TM image.
- Ocean Wave Measurements by GPS. (The 1st Report). Development of Trend Prediction Filter TPF (Real Time Filter).
- Precise Positioning of a Sea Bottom Transponder. (2). Principle of Measurements and Error Analysis.
- Development of an Observation Robot "Flying Fish" for Comprehensive Measurements of Ocean Environment. An Advanced Motion Control (Second Report).
- Study on Critical Condition of VLFS with Large Aspect Ratio.
- Wave Load on a Container Ship in Rough Seas.
- Simple Estimation Method for Long-term Distribution of Wave Induced Load based on the Severest Wave Condition Approach.
- A Study on the Shock Absorption Characteristic of Resin Protective Device.
- The performance of buffer bow structures against collision. 1st report: Collapse strength of the simplified structure models.
- Mixed analysis of shell and solid elements using overlaying mesh method.
- Stress Analysis of an undulated plate by the Combined First Order Perturbation and Alternating Method.
- Wave Induced Loads acting on Large Underwater Axisymmetric Shells.
- Dynamic Analysis of a Near Surface Disconnectable Drilling Riser.
- A Characteristic Analysis on Dynamic Stability of Form-resistant Structures in Non-conservative System. (Part 2). Chaotic Dynamics and Correlation Dimensions of Circular Arch.
- Experimental Study on Added Mass of Elastic Plate on Water.
- Identification Method of Damping for Ship Structural Vibration. (1st Report).
- A Study on Estimating the Natural Frequency for the Stiffened Plate Considering Added Mass Effects. Conventional equation based on the energy method and modification via Neural Network.
- A Practical Estimation Method of the Skin Plate Distortion Derived from Fillet Weld.
- Effects of "Residual Stress Controlled TMCP Steel Plate" on Accuracy Ship Blocks. (1st Report). Influence of Residual Stress of TMCP Steel Plate on Precision of Slit-Slot Cutting.
- Development of computer aided process planning system based on knowledge base.
- Study of Workability and Safety Using Virtual Human Model. 3rd Report. Strength of Human Body for Physical Works.
- Collaboration Management with Software Agents. (2nd report). Supporting Community Formation.
- Model Test and Analysis on Oil Skimmers at Rough Sea. (first report).
- Development of oil boom system for stormy weather. (second report).
- Study on Microscopical Mechanism of Fatigue Crack Propagation. (The 2nd Report). Fatigue Crack Propagation Behavior in 3% Si Steel.
- Brittle Fracture Controlling Parameter of Structural Steels after Large Crack Growth by Cyclic Loading. Brittle Fracture Evaluation of Steel Components Subjected to Large Scale Cyclic Loading. (Part 2).
- Effect of Strength Mismatch and Dynamic Loading on Criterion for Ductile Crack Initiation.
- Crack Initiation Strength of Structural Steel Members Having Experienced Large Compressive Strain due to Buckling Deformation. (Fourth Report).
- Operational Design of the Ferry Transportation System based on Simulation.
- An Examination about the Modal Shift to the Marine Transportation by the Modal Split Model.
190
- A Numerical Method for the Analysis of a Lifting Body in the Potential Flow.
- Computation of ship transom stern flow using a multiblock grid method.
- Simulation of Homogeneous Shear Tubulence in Stratification by DNS and LES.
- A Study of Data Comparison for Steady and Unsteady CFD simulations Using a Comparison Space.
- A Visualization Technique of Limiting Streamlines for CFD data Using Pseudo Particle Model.
- Investigation for Unsteady Cavitation and Re-entrant Jet on a Foil Section. Approach by Experiments and CFD.
- Experimental Studies on Ship Motions and Wave Loads Large Waves Using a VLCC Model and a Large-Container Ship Model.
- Wave Loads Acting on a Blunt Ship in Regular and Irregular Extreme Waves with Green Sea Loading on Decks. 1st Report: Model Teats.
- Green sea loads on hatch cvers of bulk carrier.
- On the Estimation of Wave-Induced Loads Acting on Practical Merchant Ships by a Rankine Source Method.
- Structural Safety Assessment of an Aged Ship based on Structural Monitoring Data. (First Report). Evaluation of Encountered Wave-induced Loads based on Log Book Record and Structural Monitoring Data.
- Ocean Wave Measurements by GPS. (The 2nd Report). Effects of Baseline Length And Treatment of Low Frequency Components by Hybrid Method.
- Study of a Simple Sensor for Stress History Measurements of a Structural Member using a Piezoelectric Element. Part 3. Development of a Practical Sensor with Higher Operational Function.
- On the drifting speed of floating bodies in waves.
- Study on Real-time Estimation of the Ship Motion Cross Spectra.
- A Component-type Mathematical Model of Hydrodynamic Forces in Steering Motion Derived from a Simplified Vortex Model. (5). Modification of midship part's vortex system due to turning motion.
- Crabbing Performance of a Twin Screw Vessel with Bow Thruster.
- Motion Simulation of a Sailing Boat in Oblique Waves with Three Degrees of Freedom.
- An Experimental Study on Dynamic Characteristics of Deep Ocean Water Upwelling Floating Structure for Eutrophication.
- Capsizing Probability of an Indonesian RoRo Passenger Ship in Irregular Beam Seas. (Third Report).
- A Study on Factors Related to the Capsizing Accident of Fishing Vessel "Ryuho Maru No. 5".
- Interrelationship among the Long-term Databases. (2nd Report). Properties of the Long-term Statistics which Restored the Distortion.
- An Estimation of Ocean Wave Characteristics Based on Measured Ship Motions. (4th Report). Directional Wave Spectrum Estimated from Full-scale Measurements.
- Precise Positioning of a Sea Bottom Transponder. (3). Three Dimentional Calculation.
- Suppression of Load-Swing Trough Controlling Body Motions of a Floating Crane.
- Analysis of the Unsteady Waves around a Ship Model Using Projected Light Distribution Method. Application of the Least Square Method.
- Hydraulic Model Experiments of Diffusion Induced by Density Current in a Rotating Tank.
- Estimation of upstream position of water sampled through inlet on ship hull.
- Development of SBS(Sugi Bark Sorbent) for Marine Oil Spill Response. (1st Report).
- Model Test and Analysis on Oil Skimmer at Rough Sea. (Second report).
- Evaluation of CO2 Dissolution Contained in Marine Exhaust Gas Bubbles and Reduction Ship's Frictional Resistance.
- Numerical simulation of environmental effect on the transport of Japanese sand eel larvae by the seabed sand picking.
- Ship Routing Design for the Oily Liquid Waste Collection.
- Structural Safety Evaluation of Pontoon-Type Mega-Float Considering Failure of Breakwater.
- Characteristics of Slowly-varying Wave Drifting Forces Acting on VLFS.
- Measurement of Marine Environment around Mega-float Phase-II Model.
- A study on the environmental effects of Phase-II Mega-Float model on marine ecosystem.
- Response Characteristics of Semisub-Megafloats in Winds and Waves.
- Study on prediction method of sea-shock response of floating structure considering the characteristics of propagation of earthquake waves in water and seabed. (First Report).
- An Experimental Study on Hydroelastic Responses of Elastic Floating Bodies with Air Chambers in Irregular Waves.
- A Study on Characteristics of Generated Output of the Offshore Floating Type Wave Power Device "Mighty Whale".
- A Study on Environmental Conditions at the Test Site of the Offshore Floating Wave Power Device "Mighty Whale".
- Study of Workability and Safety Using Virtual Human Model. 4th Report. Optimization of Working Access Using Response Surface Methodology.
- Study of Workability and Safety Using Virtual Human Model. 5th Report. Recovery of Strain for Welding Works.
- Application of the wearable system to shipbuilding industrial engineering.
- Studies on Ship Inspection Supporting System by the use of Product Model. 3rd Report: Proposition of Inspection Supporting System with Considering Uncertainness of the Inspection.
- Development of Shipyard Simulation System based on Petri Nets. 3rd Report: Factory Simulator introduced the concept of the Job-Shop Floor.
- A Study on the Optimization of the Hull-block Construction Process by Multi-Objective Genetic Algorithm.
- Study on an expression of phased decomposition of information on production planning.
- Study on Heat Transfer Phenomena between the Combustion Flow Field and the Heating Plate during Line Heating Process. (3rd Report).
- Study on Combustion Analysis in the Impinging Jet Flame during Line Heating Process.
- Fatigue Assessment Method considering an Effect of Mean Stress.
- Development of Ship Steel Plates with Superior Resistance to Fatigue Crack Propagation. Research on Extension of Fatigue Life of Ship Stracture. Part 1.
- Growth Process and Assessment of Fatigue Life for Surface Cracks Emanated from Stress Concentration Field.
- The Study of Fatigue Design Method based on Fatigue Crack Growth Analysis.
- Study on Fatigue Crack Initiation Process by Using Crystalline FEM analysis. (4th Report).
- Fatigue Strength of Welded Thin-Plated Titanium Joints.
- Ductile and brittle fracture initiation behavior for compressively prestrained steel.
- Development of Evaluation Parameter for Fracture Toughness Based on Statistical Mechanics.
- Strength Mismatch Effect on Ductile Crack Initiation from Notch Root of Structural Steel.
- Ductile Crack Initiation Behavior of Various Structural Materials with Reference to Initiation/Growth of Voids.
- Effects of "Residual Stress Controlled TMCP Steel Plate" on Accuracy of Ship Blocks. (2nd Report). Influence of Residual Stress of TMCP Steel Plate on Precision of Fabricating Straight Blocks.
- A Study of Dissipation Energy in the Periodic Boundary Layer. An Analytic Solution of Lower Mode Vibration of Ellipsoid in An Infinite Water.
- Study on The Optimization Method of Vibration Level for The New Standard of ISO6954. The vibration analysis by using engine inertia forces which has multiple component of cycle.
- Active Mass Damper for Ship Superstructure Vibration by Electromagnetic Control.
- Operation of the hybrid anti-rolling system on board the R/V Mirai in the North Pacific Ocean.
- Power Characteristics of the Hybrid Anti-rolling System on Board the R/V Mirai.
- Discrete Plate Bending Analysis Using Finite Cover Method.
- Mixed analysis of shell and solid elements using overlaying mesh method. (Part 2).
- Submodeling Analysis Using Recovered Stresses by Superconvergent Patch Recovery Method as Driven Variables: Application in Large Deformation Problems.
- A Stochastic State-transition and Safety Assessment for Marine Accidents Based on Human Factors. Part 2: State-transition gotten to accident and preventing countermeasures.
- A Study on Design Process Information for Collaborative Engineering.
- Development and deployment of the job supporting systems for ship building.
- Development of Dynamic Positioning System of Coupled Floating Bodies by Neural Networks.
- A Study of Ship's Guidance Control by Time-Varying LQ Controller.
- Estimation of buckling and ultimate strength of rectangular plate with cutout.
- Buckling/Ultimate Strength of Perforated Rectangular Plate under Thrust.
- On the Snap-Through Phenomena at the Secondary Buckling of Rectangular Plate under Uni-Axial Thrust.
- Plastic Collapse Strength of Hatch Cover of Bulk Carrier against Green Sea Load. (2nd Report). Hatch Cover of Side Sliding Type.
189
| Copyright (c) 2006-2007 Japan Science and Technology Agency. All Rights Reserved. | |
